Here will be the major points about tork time switch ,From here you can get the item information including description,function ,cost and some other most effective related solutions ,you will get the information that which can be the ideal to buy and come across the discount value.
if you should read extra evaluations about tork time switch or relevant item,it truly is easy to click around the image and get extra information about the solutions which you fascinating,if you want to get the solution ,you need to read more reviews.
Reviews: customer reviews...
List Price: unavailable
Sale Price: Too low to display.
No description available.
No features available.
There was an error connecting to the Amazon web service, or no results were found for your query.
If you found the write-up valuable, please pass on our data and facts for the buddies. Quite a few from the issues discussed inside the short article aren’t widely identified.
When you would like a lot far more articles like this, please take a handful of moments to offer us your feedback. Though %keywords% is typically discussed, access to information about it may very well be tough to find. Please come back and check out us after once again, we’ll have more high high quality articles for the reading pleasure.
Lacey C asked Electricians - I wired it correctly but why does the Timer System always give power to output?
Here is a wiring diagram to a Timer System that controls power to an output area: http://tork.com/pdf48w.htm I believe i have wired it correctly. But please note that i have a black jump wire attaching "H" with "C". I believe this is ok (see diagram) since the internal switch of the system controls when power is given to the "C"/"NO" combination. The problem is that when i turn on the Timer System so as to set the times the unit should provide output power i find that the output power is already coming out at the end (i check a wall socket where the output is related to) even though the timer's settings indicate that it is "off". What does this mean? Is the timer system defective? How can it be doing this? My guess is the internal switch is leaking power from the timer supply (input source) and triggering the switch to make the "C"/"NO" combination happen regardless and thus giving my output power by just giving power to the Timer System unit. Or is the jump wire the problem?
And got the following answer:
"H" (hot) and "N" (neutral) are the power feeds to run the timer motor continuously like a clock. "C" (common) is the hot wire to run through the switches to the area you want to power up at the timer setting. "NO" (normally open) and "NC" (normally closed) are the switch contacts. Normally open means that the switch is open normally. When the timer comes to the setpoint that you set (the time you want the switch to move), the motor moves a switch and the power from "C" is sent out the "NO" contacts. When the timer comes back around to the other setpoint, it moves the switch back to "NC", which is closed normally. If you check it with a ohm meter, you should have a closed switch from "C" to "NC" with no power to the timer motor. You should have no continuity from "C" to "NO". The jumper should not make any difference as long as it is from "H" to "C". Make sure the neutral for the area you want to power up is connected right. If you have power on "NO" all the time, it sounds like to me the timer is defective. I hope this helps! Good luck!!