Do you want to know the latest news about lighting timer controls? Do you want to be the first in line in regards to the developments on lighting timer controls? Are you itching to get as much as the minute information?
This artice may have the particulars that you simply will need that may be fresh from the supply! You’ll be able to subscribe to our feeds or it is possible to join the mailing list, so you are able to ensure that that you are in with all the times,and ahead of absolutely everyone!
There was an error connecting to the Amazon web service, or no results were found for your query.
There was an error connecting to the Amazon web service, or no results were found for your query.
If you found the write-up helpful, please pass on our details and information for your buddies. Many of your issues discussed inside the short article are not extensively identified.
When you’d like significantly more articles like this, please take a handful of moments to provide us your feedback. Even though %keywords% is typically discussed, access to info about it may be tough to locate. Please come back and check out us as soon as once again, we’ll have further high quality articles for your reading pleasure.
Bethney asked How do use the timer on my boiler setback control?
The control is a Varistat R.D. 601 temperature proportional setback control, the clock is analog. I talked to the manufacturer; they said this model is too old for them to support. The clock controls are not simple like those on an electric lighting timer. Also I would like your opinion on changing the other settings(ratio, etc.) from the defaults. The manufacturer did explain this to me, but I forgot the math. If you need it, I can send a digital image of the device.
And got the following answer:
I'm a homeowner in central NY State who is considering having an outdoor temperature setback control installed to reduce boiler water temperature during warm weather in order to save fuel oil. I have a oil fired 105MBTU hot water boiler with three baseboard heat zones and one indirect hot water heater zone. Boiler water is set at 180 degrees and the indirect hot water heater is set at 130 degrees. The three heating zone thermostats and hot water control are connected to four relays that turn the four circulators on and off as needed. There is no circulator that runs all the time. The boiler turns on and off as needed to maintain 180 degree water. This is not a condensing type boiler. The system works very well, but I believe I could save some money, by maintaining a lower boiler water temperature in the summer. I believe the boiler water temperature would have to be maintained at 140 degrees or above in order to heat the domestic hot water and avoid condensation of flue gas in the boiler and masonary (clay liner) chimney. what do you think? Is this worth exploring? Thanks for your help.